Upload Trace-Log - Dell C9000 Series Reference Manual

upload trace-log

Upload a trace log file from a switch CPU.
C9000 Series
Syntax
upload trace-log {cp [cmd-history]| linecard | slot-id | pe pe-id
[stack-unit unit number ] |rp } [sw-trace | hw-trace]
Parameters
rp
cp
linecard slot-id
cmd-history
hw-trace
sw-trace
pe pe-id
stack unit number
Defaults None.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Enter the keyword rp to upload a trace log from the Route
Processor.
Enter the keyword cp to upload a trace log from the Control
Processor.
Enter the linecard slot-id parameters to specify the line-
card CPU whose trace log you want to upload.
Enter the keyword cmd-history to upload the command
history from the specified CPU.
Enter the keyword hw-trace to upload the hardware trace log
from the specified CPU.
Enter the keyword sw-trace to upload the software trace log
from the specified CPU.
Enter the keyword pe and port extender ID. Range is from 0 to
255.
NOTE: The pe option is only available when the
extended bridge feature is enabled.
Enter the keyword stack unit and a stack unit number. Stack
unit range is from 0 to 7.
Description
Introduced on the C9010.
Control and Monitoring 193