Ets Commands; Dcb-Enable - Dell C9000 Series Reference Manual

Te 10/0
Te 10/0
Te 10/0
Te 10/0
Te 10/0
Te 10/0
Interface TenGigabitEthernet 10/1
Interface
------------------------------------------------------------------------
Te 10/1
Te 10/1
Te 10/1
Te 10/1
Te 10/1
Te 10/1
Te 10/1
Te 10/1

ETS Commands

The following ETS commands are supported on the Dell Networking OS.

dcb-enable

Enable data center bridging.
C9000 Series
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
P2 0
P3 0
P4 0
P5 0
P6 0
P7 0
Priority Rx XOFF Frames
P0 0
P1 0
P2 0
P3 0
P4 0
P5 0
P6 0
P7 0
Enter the pfc-queue range. To disable DCB, use the no dcb
enable command. The range is from 1 or 2.
0
0
0
0
0
0
Rx Total Frames Tx Total Frames
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
Data Center Bridging (DCB)
0
0
0
0
0
0
696