Dell C9000 Series Reference Manual page 927

Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is the Dell Networking OS version history for this command.
Version
9.9(0.0)
Usage Information Use the default interface command to set a 10-Gigabit Ethernet or 40-Gigabit
Ethernet interface to its factory-default state. By default, a physical interface is disabled
(shutdown) with no assigned IP address or switchport (no ip address).
This command removes all software settings and all L3, VLAN, VXLAN, and port-
channel configurations on a physical interface.
Example
Dell# show running-config interface tengigabitethernet 0/30
!
interface TenGigabitEthernet 0/30
no ip address
switchport
switchport mode private-vlan host
rate-interval 8
mac learning-limit 10 no-station-move
shutdown
Dell#show running-config interface vlan 33
!
interface Vlan 33
private-vlan mode isolated
no ip address
tagged TenGigabitEthernet 0/30
shutdown
Dell(conf)# default interface tengigabitethernet 0/30
Dell# show running-config interface tengigabitethernet 0/30
!
interface TenGigabitEthernet 0/30
no ip address
shutdown
Dell#show running-config interface vlan 33
!
string of port numbers, for example default interface
tengigabitethernet 1/0,1,9,11
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Description
Introduced on the C9010, FNXML, MXL, S4810, S4820T, S3048-
ON, S4048-ON, S5000, S6000, S6000-ON, and Z9500.
Interfaces 927