Dell C9000 Series Reference Manual page 494

To remove a network, use the no network ip-address mask [route-map map-
name] command.
Parameters
ip-address
mask
route-map map-
name
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
Enter an IP address in dotted decimal format of the network.
Enter the mask of the IP address in the slash prefix length format
(for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
(OPTIONAL) Enter the keyword route-map then the name of an
established route map.
Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop
all routes).
Description
Introduced on the C9010.
Introduced on the S3048–ON and S4048–ON.
Introduced on the S6000–ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Border Gateway Protocol 494