Show Boot System - Dell C9000 Series Reference Manual

Example
Dell#show boot bmp
Reload type is set to normal mode. BMP process is in disabled
state

show boot system

Display information about boot images currently stored on the system.
C9000 Series
Syntax
show boot system all
From a PE console, use the following:
show boot system {stack-unit unit number | all}
Parameters
all
stack-unit unit-
number
Defaults none
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
Example
Dell#show boot system all
Current system image information in the system:
===============================================
Type
Display the boot images stored on the system for the Control
Processor, Route Processor, and line card CPUs.
From a PE console, display boot image information on all the
unit.
Display the boot image information for a specified stack-unit.
The stack-unit number range is from 0 to 7.
• EXEC
• EXEC Privilege
Description
Introduced on the C9010 and C1048P.
Introduced on the Z9500.
Boot Type A B
File Management 218