Dcb Commands; Dcb-Enable - Dell C9000 Series Reference Manual

DCB Commands

The following DCB command is supported on the Dell Networking OS.

dcb-enable

Enable data center bridging.
C9000 Series
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.1)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Enter the pfc-queue range. To disable DCB, use the no dcb
enable command. The range is from 1 or 2.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON .
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB) 680