Set Level - Dell C9000 Series Reference Manual

none
additive
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
ip community-list
Commands
match community
]neighbor send-community
show ip bgp community
show ip community-lists

set level

To specify the IS-IS level or OSPF area to which matched routes are redistributed, configure a filter.
C9000 Series
Syntax
set level {backbone | level-1 | level-1-2 | level-2 | stub-area}
Enter the keyword none to remove the community attribute
from routes meeting the route map criteria.
(OPTIONAL) Enter the keyword additive to add the
communities to already existing communities.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures community access list.
— redistributes routes that match the COMMUNITY attribute.
— assigns the COMMUNITY attribute.
— displays BGP community groups.
— displays configured Community access lists.
Access Control Lists (ACL) 379