Cam-Audit Linecard - Dell C9000 Series Reference Manual

Usage Information For the new settings to take effect, save the new CAM settings to the startup-config
(write-mem or copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires four blocks
and these blocks cannot be reallocated. The total number of blocks must be equal to
12. The ipv4acl profile range is from 0 to 8.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 12.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is
from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the reload
conditional nvram-cfg-change command.
You can use the cam-acl default command in Configuration Terminal Batch mode
to reset ACL CAM entries to default settings in a dual-homing setup.

cam-audit linecard

Enable audit of the IPv4 forwarding table on all line cards.
C9000 Series
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
all
ipv4-fib
interval time-in-
minutes
Defaults Disabled
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
Version
9.10(0.0)
Enter the keyword all to enable CAM audit on all line cards.
Enter the keyword ipv4-fib to designate the CAM audit on the
IPv4 forwarding entries.
Enter the keyword interval followed by the frequency in
minutes of the CAM audit. Range: 5 to 1440 minutes (24 hours).
Default: 60 minutes.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Control and Monitoring 77