Dell C9000 Series Reference Manual page 941

Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Example (Single
This example shows how to define an interface range macro named test. Execute the
Range)
show running-config command to display the macro definition.
Dell(config)# define interface-range test tengigabitethernet
0/0-3,
tengigabitethernet 1/0-47, tengigabitethernet 2/0-89
Dell# show running-config | grep define
define interface-range test tengigabitethernet 0/0-3,
tengigabitethernet 1/0-47,
tengigabitethernet 2/0-89
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then the
tunnel ID. The range is from 1 to 16383.
• For a VLAN, enter the keyword vlan then a number from 1
to 4094.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Added support for 4093 VLANs on E-Series ExaScale. Prior
releases supported 2094.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Interfaces 941