Hop-Limit - Dell C9000 Series Reference Manual

Version
9.7(0.0)
9.7(0.0)

hop-limit

Enable the verification of the advertised hop count limit. If this command is not configured, the verification
process is bypassed.
C9000 Series
Syntax
hop-limit {maximum | minimum limit}
To reset the hop count limit, use the no hop-limit {maximum | minimum limit}
command.
Parameters
maximum limit
minimum limit
Defaults none
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.8(0.0)
9.7(0.0)
Description
Introduced on the S6000-ON.
Introduced on the S4810, S4820T, S5000, S6000, and Z9000
switches.
Enter the keyword maximum then the hop limit value. The range
is from 0 to 254.
Enter the keyword minimum then the hop limit value. The range
is from 0 to 254.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Neighbor Discovery Protocol (NDP) 1443