Ipv6 Unicast-Routing - Dell C9000 Series Reference Manual

route prefixes are cleared from RTM
Dell(conf)#no ipv6 unicast-host-route
Warning: Command will take effect for existing routes only when
IPv6
route prefixes are cleared from RTM
Dell(conf)#

ipv6 unicast-routing

Enable IPv6 Unicast routing.
C9000 Series
Syntax
ipv6 unicast-routing
To disable unicast routing, use the no ipv6 unicast-routing command.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.0.0.0
8.3.19.0
8.3.7.0
8.4.2.1
8.2.1.0
7.8.1.0
7.4.1.0
Usage Information Because this command is enabled by default, it does not appear in the running
configuration. When you disable unicast routing, the no ipv6 unicast-routing
command is included in the running configuration. Whenever unicast routing is
disabled or re-enabled, the system generates a syslog message indicating the action.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
IPv6 Basics 1284