Power Inline Restore Pe - Dell C9000 Series Reference Manual

consumption by the powered device. Power negotiation via LLDP is not supported in
static mode.
Use this command in Configuration Terminal Batch mode to manage inline power
supply in a dual-homing setup.
The following examples show power management mode, "class" configured for the
port extender 255.
Example
Dell(conf)#power inline mode pe 0 stack-unit 0 static
Dell#show power inline pe 0 stack-unit 0
Global inline power Threshold :
Power Reserved for inline Power:
Total Inline Power Consumed:
Remaining inline power Available:
Power Management Mode:
Interface
PoE Port
Priority
-------------
--------
PeGi 0/0/0
low

power inline restore pe

Enable the temporarily suspended PoE power supply to all the ports in a port extender unit.
C9000 Series
Syntax
power inline restore pe pe-id stack-unit unit number
Parameters
pe pe-id
stack-unit unit
number
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Inline Power
LLDP
Max / Alloc
Support
(Watts)
------------
------
30.00/0.00
0
Enter the keyword pe and the port extender ID. Range is from 0
to 255.
Enter the keyword stack-unit and the stack-unit number.
Range is from 0 to 7.
99
841W
0W
841W
Static
Inline Power Class
Consumed
(Watts)
------------ -------
0.00 NO_PD
Port Extenders (PE)
Device
Type
------
-
1756