Ip Pim Sparse-Mode Sg-Expiry-Timer - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.5(0.0)
8.3.19.0
8.3.12.0
8.1.1.0
Usage Information This command is applicable to last hop routers on the shared tree towards the
rendezvous point (RP).

ip pim sparse-mode sg-expiry-timer

Enable expiry timers globally for all sources.
C9000 Series
Syntax
ip pim sparse-mode sg-expiry-timer seconds
To disable configured timers and return to default mode, use the no ip pim sparse-
mode sg-expiry-timer command.
Parameters
seconds
Defaults Disabled. The default expiry timer (with no times configured) is 210 sec.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON. Added support for VRF.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Enter the number of seconds the S, G entries are retained. The
range is from 211 to 65535.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
PIM-Sparse Mode (PIM-SM) 1686