Match Ip Access-Group - Dell C9000 Series Reference Manual

Command Modes CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in and
conf-qos-policy-out; wred)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
pre-7.7.1.0
Related
policy-map-input
Commands
policy-map-output
qos-policy-input
qos-policy-output
wred-profile

match ip access-group

Configure match criteria for a class map, based on the access control list (ACL).
C9000 Series
Syntax
match ip access-group access-group-name [set-ip-dscp value]
To remove ACL match criteria from a class map, use the no match ip access-
group access-group-name [set-ip-dscp value] command.
Parameters
access-group-
name
set-ip-dscp value
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced.
— creates an input policy map.
— creates an output policy map.
— creates an input QoS-policy on the router.
— creates an output QoS-policy on the router.
— creates a WRED profile.
Enter the ACL name whose contents are used as the match
criteria in determining if packets belong to the class the class-
map specifies.
(OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP value.
The range is from 0 to 63.
Quality of Service (QoS) 1804