track interface ipv6 routing
Configure object tracking on the routing status of an IPv6 Layer 3 interface.
C9000 Series
Syntax
track object-id interface interface ipv6 routing
To return to the default setting, use the no track object-id command.
Parameters
object-id
interface
Defaults
none
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
•
track ipv6 route metric threshold
an IPv6 route metric.
•
track ipv6 route reachability
IPv6 route.
Enter the ID number of the tracked object. The range is from 1
to 500.
Enter one of the following values:
•
•
•
•
•
•
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
– configures object tracking on the threshold of
– configures object tracking on the reachability of an
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
For a port channel interface, enter the keywords port-
channel then a number.
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Object Tracking
1475