Version
8.1.1.0
7.7.1.0
7.5.1.0
7.4.1.0
Example
Dell(conf-mon-sess-2)#show config
!
monitor session 2 type rpm
source fortyGigE 0/60 destination remote-vlan 300 direction rx
source Port-channel 10 destination remote-vlan 300 direction rx
no disable
Dell#
show monitor session
Display port extender (PE) Gigabit Ethernet interface monitoring information.
C9000 Series
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor session
command.
To display monitoring information for port extender interface, when added as a source
port, use the do show monitor session command in CONFIGURATION mode.
Parameters
session-ID
Defaults
none
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter a session identification number. The range is
from 0 to 65535.
•
CONFIGURATION
•
EXEC
•
EXEC Privilege
Port Monitoring
1767