Clear Lldp Counters - Dell C9000 Series Reference Manual

To remove advertised management TLVs, use the no advertise management-tlv
{management-address | system-capabilities | system-description |
system-name} command.
Parameters
management-
address
system-
capabilities
system-
description
system-name
Defaults none
Command Modes INTERFACE (conf-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.1.(0.0)
8.3.19.0

clear lldp counters

Clear LLDP transmitting and receiving counters for all physical interfaces or a specific physical interface.
C9000 Series
Syntax
clear lldp counters interface
Parameters
interface
Enter the keywords management-address to advertise the
management IP address TLVs to the specified interface.
Enter the keywords system-capabilities to advertise the
system capabilities TLVs to the specified interface.
Enter the keywords system-description to advertise the
system description TLVs to the specified interface.
Enter the keywords system-name to advertise the system name
TLVs to the specified interface.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000 and S4810.
Introduced on the S4820T.
Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Link Layer Discovery Protocol (LLDP) 1364