Ipv4 Unicast-Host-Route - Dell C9000 Series Reference Manual

Version
7.5.1.0
6.1.1.0

ipv4 unicast-host-route

Enable the storage of IPv4 route prefixes in the L3 host table.
C9000 Series
Syntax
[no] ipv4 unicast-host-route
Defaults Disabled; by default, all IPv4 route prefixes are stored installed only in the Longest Prefix
Match (LPM) table.
Command Modes CONFIGURATION
Command History
Version
9.9(0.0)
9.5(0.1)
9.3(0.1)
Usage Information Route prefixes stored in the L3 host table are managed using ECMP next-hop
forwarding.
A warning message is displayed after you enter the command stating that this setting
takes effect for existing routes only when IPv4 route prefixes are cleared from the LPM
routing table (RTM). To enable storage of IPv4 route prefixes in the LPM table, disable
this setting by entering the no ipv4 unicast-host-route command.
Example
Dell(conf)#ipv4 unicast-host-route
Warning: Command will take effect for existing routes only when
IPv4
route prefixes are cleared from RTM
Dell(conf)#no ipv4 unicast-host-route
Description
Introduced on the C-Series.
Introduced on the E-Series.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S6000.
IPv4 Routing 1204