Ip Igmp Snooping Flood - Dell C9000 Series Reference Manual

Version
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage Information Queriers normally send some queries when a leave message is received prior to
deleting a group from the membership database. There may be situations when you
require a fast deletion of a group. When you enable IGMP fast leave processing, the
switch removes an interface from the multicast group as soon as it detects an IGMP
version 2 leave message on the interface.

ip igmp snooping flood

Control the flooding behavior of unregistered multicast data packets.
C9000 Series
Syntax
ip igmp snooping flood
Defaults Enabled.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
Description
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Internet Group Management Protocol (IGMP) 1147