Show Ip Cam Linecard - Dell C9000 Series Reference Manual

show ip cam linecard

View CAM entries for a port pipe on a line card..
C9000 Series
Syntax
show ip cam linecard number port-set pipe-number [ip-address mask
[longer-prefixes] | index index-number | summary | vrf vrf
instance]
Parameters
number
pipe-number
ip-address mask
[longer-prefix]
index index-
number
summary
vrf instance
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.7.0
Enter the number of the line card.
Enter the number of the line card's port-pipe. The range is from
0 to 1.
(OPTIONAL) Enter the IP address and mask of a route to CAM
entries for that route only. Enter the keyword longer-
prefixes to view routes with a common prefix.
(OPTIONAL) Enter the keyword index then the CAM index
number. The range depends on CAM size.
(OPTIONAL) Enter the keyword summary to view a table listing
route prefixes and the total number of routes that can be
entered into the CAM.
(OPTIONAL) E-Series Only: Enter the keyword vrf then the VRF
instance name to show CAM information as it applies to that
VRF instance.
• EXEC
• EXEC Privilege
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
IPv4 Routing 1215