Group - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Usage Information Use the interface port-channel command to access this command.

You cannot add an interface to a Port Channel if the interface contains an IP address in

its configuration. Only the shutdown, description, mtu, and ip mtu commands can

be configured on an interface if it is added to a Port Channel. The mtu and ip mtu

commands are only available when the chassis is in Jumbo mode.

Link MTU and IP MTU considerations for Port Channels are:

When an interface is removed from a Port Channel with the no channel-member

command, the interface reverts to its configuration prior to joining the Port Channel.

An interface can belong to only one Port Channel.

interface port-channel

group

Group two LAGs in a supergroup ("fate-sharing group" or "failover group").

C9000 Series

group group_number port-channel number port-channel number

To remove an existing LAG supergroup, use the no group group_number command.

group_number

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

All members must have the same link MTU value and the same IP MTU value.

The Port Channel link MTU and IP MTU must be less than or equal to the link MTU

and IP MTU values configured on the channel members. For example, if the

members have a link MTU of 2100 and an IP MTU 2000, the Port Channel's MTU

values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.

— assigns a descriptive text string to the interface.

— creates a Port Channel interface.

— disables/enables the port channel.

Enter an integer from 1 to 32 that uniquely identifies this LAG

fate-sharing group.

Table of Contents