Linecard Portmode - Dell C9000 Series Reference Manual

linecard portmode

Split a single 40G port into four 10G ports on the switch.
C9000 Series
Syntax
linecard slot-id port number portmode quad
Parameters
linecard slot-id
number
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
Usage Information Enabling quad mode on a port removes the interface configurations (if any) on the port
after a save and reload. Be sure that the port is removed from other L2 and L3 feature
configurations.
You must save and reload the system for the 40G to 4x10G port change to take effect.
This command cannot be used if LR4 optics are inserted in the 40G port.
Enter the slot ID of a line card to reset. The range of slot IDs is
from 0 to 11.
Enter the port number of the 40G port to be split. The port
range is from 0 to 20. A 40G port number is a multiple of 4; for
example, 0, 4, 8, 12, ... 120, 124, 128).
Description
Introduced on the C9010.
Introduced on the Z9500.
Interfaces 945