Duplex (Management) - Dell C9000 Series Reference Manual

interface Vlan 33
private-vlan mode isolated
no ip address
shutdown
Related show
Commands

duplex (Management)

Set the mode of the Management and Port Extender Gigabit Ethernet (PeGigE) interfaces.
C9000 Series
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half
full
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.11.1
8.1.1.0
7.5.1.0
7.4.1.0
Usage Information This command applies to the Management interface on the route processor modules
(RPMs) and port extender (PE) ports.
running-config— displays the current configuration.
Enter the keyword half to set the Management interface to
transmit only in one direction.
Enter the keyword full to set the Management interface to
transmit in both directions.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Documentation modified — added Management to distinguish
from duplex (10/100 Interfaces).
Interfaces 928