Dell C9000 Series Reference Manual page 444

Parameters
vrf vrf-name
ipv4 multicast
ipv4 unicast
ipv6 unicast
ipv4-address
mask
ipv6–address
mask
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.4.(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information After you enter this command, the software deletes the history routes and returns the
suppressed routes to the Active state.
(OPTIONAL) Enter the keyword vrf and then the name of the
VRF to clear information on route dampening corresponding to
that VRF
NOTE: You can use this attribute on a specific VRF to
remove history routes corresponding to that VRF. You
can also use this attribute to return the suppressed
routes corresponding to a specific VRF to an active state.
(OPTIONAL) Enter the keyword ipv4 followed by the keyword
multicast to clear the ipv4 multicast routes.
(OPTIONAL) Enter the keyword ipv4 followed by the keyword
unicast to clear the ipv4 unicast routes.
(OPTIONAL) Enter the keyword ipv6 followed by the keyword
unicast to clear the ipv6 unicast routes.
(OPTIONAL) Enter an IPv4 address in dotted decimal format and
the prefix mask in slash format (/x) to clear dampening
information only that BGP neighbor.
(OPTIONAL) Enter the IPv6 address and the network mask to
clear information on IPv6 route dampening.
Description
Introduced on the C9010.
Introduced on the S3048–ON and S4048–ON.
Added the ipv4 multicast and ipv6 unicast parameters.
Added support for VRF.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol 444