Dell C9000 Series Reference Manual page 301

fragments
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
6.5.1.0
Usage Information Use the order option only when you use policy-based QoS on the switch. For more
information, refer to the Quality of Service chapter in the C9000 Configuration Guide.
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may
become busy as it has to log these packet details.
Use the monitor option only when you are using flow-based monitoring. For more
information, refer to the Port Monitoring chapter in the C9000 Configuration Guide.
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port
operators (for example, gt, lt or range) may require more than one entry. The range of
Monitoring" section in the Port Monitoring chapter of the Dell
Networking OS Configuration Guide.
Enter the keyword fragments to use ACLs to control packet
fragments.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the keyword dscp.
Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Expanded to include the optional QoS order priority for the
ACL entry.
NOTE: When ACL logging and byte counters are configured simultaneously, byte
counters may display an incorrect value. Configure packet counters with logging
instead.
Access Control Lists (ACL) 301