set tag
set comm-list delete
To remove the specified community list from the BGP route's COMMUNITY attribute, configure a filter.
C9000 Series
Syntax
set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the no set comm-
list community-list-name delete command.
Parameters
community-list-
name
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage Information The community list used in the set comm-list delete command must be
configured so that each filter contains only one community. For example, the filter
deny 100:12 is acceptable, but the filter deny 120:13 140:33 results in an error.
— specify the tag assigned to redistributed routes.
Enter the name of an established Community list, up to 140
characters.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Access Control Lists (ACL)
377