Dell C9000 Series Reference Manual page 288

in
out
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Usage Information If you do not attach an ingress or egress access-list to an interface, no information
displays and you return to the DELL# prompt.
Example
Dell# show ip access-lists out
Standard Egress IP access list first
seq 5 permit any count
seq 10 deny any count (0 packets)
Standard Egress
seq 5 permit any
Standard Egress
seq 5 permit any count
seq 10 deny any count (0 packets)
Standard Egress IP access list second
seq 5 permit host 1.1.1.1 count
Extended Egress
seq 5 permit tcp any eq 1 any
seq 10 deny ip any host 11.11.11.11 count (0 packets)
• For a VLAN interface, enter the keyword vlan then the
slot/port number.
• For a Port Channel interface, enter the keyword port-
channel then a port channel number.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
Enter the keyword in to display information for an ip ingress or
inbound access-list attached to an interface.
Enter the keyword out to display information for an ip egress or
outbound access-list attached to an interface.
Description
Introduced on the C9010.
bytes (0 bytes)
IP access list five
IP access list four
bytes (0 bytes)
IP access list ten
bytes (0 bytes)
Access Control Lists (ACL) 288