Dell C9000 Series Reference Manual page 65

2 Enter the router ospf {process-id} command. The prompt changes to include (conf-router_ospf-
id).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER RIP
mode by using the router rip command.
ROUTER OSPFV3 Mode
To configure OSPF for IPv6, use ROUTER OSPFV3 mode. For more information, see
Open Shortest Path First (OSPFv2 and
To enter ROUTER OSPFV3 mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the ipv6 router ospf {process-id} command. The prompt changes to include (conf-ipv6-
router_ospf).
You can return to CONFIGURATION mode by using the exit command.
ROUTER RIP Mode
To enable and configure Router Information Protocol (RIP), use ROUTER RIP mode. For more information,
see Routing Information Protocol
To enter ROUTER RIP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the router rip command. The prompt changes to include (conf-router_rip).
You can return to CONFIGURATION mode by using the exit command.
SPANNING TREE Mode
To enable and configure the Spanning Tree protocol, use SPANNING TREE mode. For more information, see
Spanning Tree Protocol
To enter SPANNING TREE mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the protocol spanning-tree stp-id command. The prompt changes to include (conf-stp).
You can return to CONFIGURATION mode by using the exit command.
TRACE-LIST Mode
To configure a Trace list, use TRACE-LIST mode.
To enter TRACE-LIST mode:
OSPFv3).
(RIP).
(STP).
CLI Basics 65