Fcoe Transit - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

To enable the FCoE Transit feature and configure FIP snooping, use the following Dell Networking Operating

System commands on the C9000 platform.

In a converged Ethernet network, a switch can operate as an intermediate Ethernet bridge to snoop on FIP

packets during the login process on Fibre Channel over Ethernet (FCoE) forwarders (FCFs). Acting as a transit

FIP snooping bridge, the switch uses dynamically created access control lists (ACLs) to permit only authorized

FCoE traffic to transmit between an FCoE end-device and an FCF.

clear fip-snooping database interface vlan

clear fip-snooping statistics

debug fip snooping

debug fip snooping rx

feature fip-snooping

fip-snooping enable

fip-snooping fc-map

fip-snooping max-sessions-per-enodemac

fip-snooping port-mode fcf

fip-snooping port-mode fcoe-trusted

show fip-snooping config

show fip-snooping enode

show fip-snooping fcf

show fip-snooping sessions

show fip-snooping statistics

show fip-snooping system

show fip-snooping vlan

FCoE Transit

Table of Contents