Dell C9000 Series Reference Manual page 958

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.00
9.2(1.0)
9.2(0.0)
9.1(0.0)
8.3.12.1
8.3.11.4
8.3.11.1
8.5.1.0
8.3.7.0
8.2.1.2
8.2.1.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.4.1.0
6.3.1.0
Usage Information Use the show interfaces command for details on a specific interface. Use the show
interfaces linecard command for details on all interfaces on the designated line
card.
Description
Introduced on the C9010 and C1048P.
Introduced on the Z9500.
Added support for the tunnel interface type.
Updated ManagementEthernet output to include two global
IPv6 addresses on S4810 and Z9000 and added output example
showing OpenFlow instance ID.
Updated command output to support multiple IPv6 addresses
on S4810.
Output expanded to support eSR4 optics in Z9000.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Included SFP and SFP+ optics power detail in the E-Series and
C-Series output.
Added support for 4093 VLANs on the E-Series ExaScale. Prior
releases supported 2094.
Introduced on the E-Series ExaScale.
Output expanded to include SFP+ media on the C-Series.
Introduced on the S Series.
Introduced on the C-Series.
Changed the organization of the display output.
Added the Pluggable Media Type field in the E-Series TeraScale
output.
NOTE: In the CLI output, the power value is rounded to a 3-digit value. For
receive/transmit power that is less than 0.000, an snmp query returns the
corresponding dbm value even though the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until it
reaches the maximum line rate. When the maximum line rate is reached, there is
no change in the line-rate.
Interfaces 958