Ip Msdp Sa-Filter - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
Usage Information Modifications to the ACL do not have an immediate effect on the sa-cache.
To apply the redistribute filter to entries already present in the SA cache, use the clear
ip msdp sa-cache local command.

ip msdp sa-filter

Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the specified
peer.
C9000 Series
Syntax
ip msdp sa-filter {in | out} peer-address list [access-list name]
Remove this configuration using the no ip msdp sa-filter {in | out} peer
address list [access-list name] command.
Parameters
in
out
peer-address
access-list name
Defaults Not configured.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the keyword in to enable incoming SA filtering.
Enter the keyword out to enable outgoing SA filtering.
Enter the peer address of the MSDP peer in a dotted decimal
format (A.B.C.D.).
Enter the name of an extended ACL that contains permitted SAs.
If you do not use this option, all local entries are blocked.
Multicast Source Discovery Protocol (MSDP) 1413