Cascade Interface - Dell C9000 Series Reference Manual

• Power over Ethernet (PoE)

cascade interface

Configure an interface as a cascade interface.
C9000 Series
Syntax
cascade interface interface slot/port-range [peer]
Parameters
interface interface
slot/port-range
peer
Default None
Command Modes
PE CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
Enter interface and specify the interface supported on the
switch. The TenGigabit Ethernet interface is the only interface
type supported for this feature.
Enter the slot/port-range to specify a linecard and either a single
port number, a port range, or a combination of both for auto-
LAG configuration.
Slot number range is from 0 to 9. In linecard slots 0 to 9, the
range of port numbers is from 0 to 23.
Enter peer to configure the VLT peer in a dual-homing setup.
This parameter is available only in the Configuration Terminal
Batch Mode.
Description
Introduced the Configuration Terminal Batch mode and the
peer parameter on C9010.
Introduced on the C9010.
Port Extenders (PE) 1713