Version
8.3.12.0
8.4.1.0
Usage Information Use this command to create an object that tracks the routing state of an IPv6 Layer 3
interface:
Related
Commands
track ipv6 route metric threshold
Configure object tracking on the threshold of an IPv4 route metric.
C9000 Series
Syntax
track object-id ipv6 route ipv6-address/prefix-len metric
threshold
To return to the default setting, use the no track object-id command.
Parameters
object-id
ipv6-address/
prefix-len
Defaults
none
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Description
Introduced on the S4810.
Introduced.
•
The status of the IPv6 interface is UP only if the Layer 2 status of the interface is
UP and the interface has a valid IP address.
•
The Layer 3 status of an IPv6 interface goes DOWN when its Layer 2 status goes
down (for a Layer 3 VLAN, all VLAN ports must be down) or the IP address is
removed from the routing table.
•
show track ipv6 route
configuration, current state, and clients which track the route.
•
track interface ip routing
IPv4 Layer 3 interface.
Enter the ID number of the tracked object. The range is from 1
to 500.
Enter an IPv6 address in X:X:X:X::X format. The valid IPv6 prefix
lengths are from /0 to / 128.
Description
Introduced on the C9010.
– displays information about tracked IPv6 routes, including
– configures object tracking on the routing status of an
Object Tracking
1476