Show Config - Dell C9000 Series Reference Manual

Version
8.3.11.1
7.8.1.0
6.3.1.0
Usage Information Configure the router to set the overload bit when a router experiences problems, such
as a memory shortage because of an incomplete link state database. This can result in
an incomplete or inaccurate routing table. If you set the overload bit in its LSPs, other
routers ignore the unreliable router in their SPF calculations until the router has
recovere
d.

show config

Display the changes you made to the IS-IS configuration. Default values are not shown.
C9000 Series
Syntax
show config
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.1
Description
Introduced on the Z9000.
Added support for multi-topology ISIS.
Introduced.
NOTE: You can configure a single system wide value that is common for both
IPv4 and IPv6 address.
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Intermediate System to Intermediate System (IS-IS) 1106