Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,te-1/0-47,te-2/0-89)#
Related
Commands
interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
C9000 Series
Syntax
interface range macro name
Parameters
name
Defaults
none
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.2.1.0
Example (Single
This example displays the macro named test.
Range)
Dell(config)# interface range macro test
Dell(config-if-range-te-0/0-3,te-1/0-47,te-2/0-89)#
Dell
•
interface range
– configures a range of command (bulk configuration)
•
interface range macro name
Enter the name of an existing macro.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
– runs an interface range macro.
Interfaces
942