Dell C9000 Series Reference Manual page 536

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Usage Information The following describes the show ip bgp peer-group command shown in the

following example.

Line beginning

Administratively

Minimum time

For address family

BGP neighbor

Number of peers

Dell#show ip bgp peer-group

Peer-group port0, remote AS 200

BGP version 4

Minimum time between advertisement runs is 30 seconds

For address family: IPv4 Unicast

BGP neighbor is port0, peer-group external

Update packing has 4_OCTET_AS support enabled

Number of peers in this group 1

Maximum limit on the accepted connections 256

Peer-group members (* - outbound optimized):

Displays the peer group's name.

Displays the peer group's status if the peer group is not enabled.

If you enable the peer group, this line is not displayed.

Displays the BGP version supported.

Displays the time interval between BGP advertisements.

Displays IPv4 Unicast as the address family.

Displays the name of the BGP neighbor.

Displays the number of peers currently configured for this peer

Lists the IP addresses of the peers in the peer group. If the

address is outbound optimized, an * is displayed next to the IP

neighbor peer-group (assigning peers)

neighbor peer-group (creating group)

— assigns a peer to a peer-group.

— creates a peer group

Border Gateway Protocol

Chapters

Table of Contents