Dell C9000 Series Reference Manual page 102

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

To return to the default setting, use the no ip tftp source-interface

interface command.

The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

Command Modes

CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Enter the following keywords and slot/port or number

information:

For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

For a Port Channel, enter the keyword port-channel

then a number. The range is 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Introduced on the C9010.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4820T.

Added support for 4-port 40G line cards on ExaScale.

Increased number of VLANs on ExaScale to 4094 (was 2094).

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

Original command

Control and Monitoring

Chapters

Table of Contents