Show Ip Access-Lists - Dell C9000 Series Reference Manual

Usage Information Use the order option only when you use policy-based QoS on the switch. For more
information, refer to the Quality of Service chapter of the C9000 Series Configuration
Guide. The following conditions apply:
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may
become busy as it has to log these packets' details.
By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The
default frequency at which ACL logs are generated is five minutes. By default, flow-
based monitoring is not enabled.
Use the monitor option only when you are using flow-based monitoring. For more
information, refer to the Port Monitoring chapter of the C9000 Series Configuration
Guide.
Related
deny
Commands
permit

show ip access-lists

Display inbound or outbound IP access-list information based on a given option.
C9000 Series
Syntax
show ip access-lists {interface interface [in | out]}
Parameters
interface
• The seq sequence-number command is applicable only in an ACL group.
• The order option works across ACL groups that have been applied on an
interface via the QoS policy framework.
• The order option takes precedence over seq sequence-number.
• If sequence-number is not configured, the rules with the same order value are
ordered according to their configuration order.
• If sequence-number is configured, the sequence-number is used as a tie breaker
for rules with the same order.
— configures a filter to drop packets.
— configures a filter to forward packets.
Enter the keyword interface then one of the following
keywords and slot/port or pe-id / stack-unit / port-id
information:
•
•
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Access Control Lists (ACL) 287