Neighbor Remove-Private-As - Dell C9000 Series Reference Manual

This command creates a peer and the newly created peer is disabled (Shutdown).
Related
router bgp
Commands
bgp four-octet-as-support

neighbor remove-private-as

Remove private AS numbers from the AS-PATH of outgoing updates.
C9000 Series
Syntax
neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-
name} remove-private-as command.
Parameters
ip-address
peer-group-name
Defaults Disabled (that is, private AS number are not removed).
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information Applies to EBGP neighbors only.
— enters ROUTER BGP mode and configures routes in an AS.
— enables 4-byte support for the BGP process.
Enter the IP address of the neighbor to remove the private AS
numbers.
Enter the name of the peer group to remove the private AS
numbers.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series. Added 4-byte support.
Border Gateway Protocol 483