Dell(config-ext-macl)#remark 15 ARP
Dell(config-ext-macl)#seq 20 permit any any ev2 eq 806 count bytes
Dell(config-ext-macl)#remark 25 IPv6
Dell(config-ext-macl)#seq 30 permit any any ev2 eq 86dd count
bytes
Dell(config-ext-macl)#seq 40 permit any any count bytes
Dell(config-ext-macl)#exit
Dell(conf)#do show mac accounting access-list snickers interface
te 0/47 in
Extended mac access-list snickers on TenGigabitEthernet 0/47
seq 10 permit any any ev2 eq 800 count bytes (559851886 packets
191402152148
bytes)
seq 20 permit any any ev2 eq 806 count bytes (74481486 packets
5031686754
bytes)
seq 30 permit any any ev2 eq 86dd count bytes (7751519 packets
797843521 bytes)
Related
mac access-list standard
Commands
show mac accounting access-list
counters (if configured).
permit
To pass packets matching the criteria specified, configure a filter.
C9000 Series
Syntax
permit {any | host mac-address | mac-source-address mac-source-
address-mask} {any | host mac-address | mac-destination-address
mac-destination-address-mask} [ethertype operator] [count [byte]]
| [log [interval minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
Parameters
any
host
mac-source-
address
•
Use the no seq sequence-number command if you know the filter's sequence
number.
•
Use the no permit {any | host mac-address | mac-source-address
mac-source-address-mask} {any | mac-destination-address mac-
destination-address-mask} command.
Enter the keyword any to forward all packets.
Enter the keyword host then a MAC address to forward packets
with that host address.
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
— configures a standard MAC access list.
— displays MAC access list configurations and
Access Control Lists (ACL)
346