Set Weight - Dell C9000 Series Reference Manual

Related
set automatic-tag
Commands
set level
set metric
set metric-type

set weight

To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.
C9000 Series
Syntax
set weight weight
To delete a weight specification, use the no set weight weight command.
Parameters
weight
Defaults router-originated = 32768; all other routes = 0
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
— specifies the metric value assigned to redistributed routes.
— specifies the route type assigned to redistributed routes.
Enter a number as the weight used by the route meeting the
route map specification. The range is from 0 to 65535. The
default is router-originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, the
routes with a higher weight are preferred.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Access Control Lists (ACL) 387