Dot1X Mac-Auth-Bypass - Dell C9000 Series Reference Manual

Related show dot1x interface
Commands

dot1x mac-auth-bypass

Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity
Request frame, the system attempts to authenticate the host based on its MAC address.
C9000 Series
Syntax
dot1x mac-auth-bypass
To disable MAC authentication bypass on a port, use the no dot1x mac-auth-
bypass command.
Defaults Disabled
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.4.1.0
Related dot1x auth-type mab-only
Commands
• Multi-supplicant mode authenticates every device attempting to connect to the
network on the authenticator port.
• Use this command in Interface Batch Mode to enable single-host or multi-host
authentication in a dual-homing setup.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
802.1X 249