Dell C9000 Series Reference Manual page 63

2 Enter the port-channel failover-group command. The prompt changes to include (conf-po-
failover-grp).
You can return to CONFIGURATION mode by using the exit command.
PREFIX-LIST Mode
To configure a prefix list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the ip prefix-list command. Include a name for the prefix list. The prompt changes to
include (conf-nprefixl).
You can return to CONFIGURATION mode by using the exit command.
PRIORITY GROUP Mode
To create an ETS priority group, use PRIORITY GROUP mode.
To enter PRIORITY GROUP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the priority-group command then the group name. The prompt changes to include (conf-pg).
You can return to CONFIGURATION mode by using the exit command.
PROTOCOL GVRP Mode
To enable and configure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For more
information, see GARP VLAN Registration
To enter PROTOCOL GVRP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the protocol gvrp command. The prompt changes to include (config-gvrp).
You can return to CONFIGURATION mode by using the exit command.
QOS POLICY Mode
To configure ETS bandwidth allocation and scheduling for priority traffic, use QOS POLICY mode.
To enter QOS POLICY mode:
1 Verify that you are logged in to CONFIGURATION mode.
(GVRP).
CLI Basics 63