Dell C9000 Series Reference Manual page 195

{{high | low} cpu-
utilization-
threshold-
percentage}
Defaults
•
•
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Usage Information When the total CPU utilization exceeds the configured threshold for the specified time,
a threshold notification is sent as an SNMP trap. If a low threshold value is not specified,
the low threshold value is set to the same value as the high threshold value. The system
generates a Syslog and SNMP trap each time the configured CPU threshold is crossed.
Use this command in Configuration Terminal Batch mode to configure the CPU
utilization thresholds in a dual-homing setup.
Example
Dell(conf)# util-threshold cpu 5sec cp high 50
In this example, the low threshold value is not specified so the system takes the value
set for the high threshold value. In all other cases, the low threshold value must be
equal to or less than the high threshold value.
Related
•
Commands
Enter a percentage value to configure the high or low threshold
level for the time in which a switch CPU can be used. The
percentage of CPU use ranges from 0 to 100.
NOTE:
traps.
High CPU utilization threshold: 1 min = 85%, 5 min = 80%
Low CPU utilization threshold: 1 min = 75%, 5 min = 70%
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
NOTE: The 5 sec util-threshold cpu command is disabled by default on all
switches. To enable the command, enter util-threshold cpu 5sec all
high {value greater than zero}. To disable the Syslog and traps for the 5 sec CPU
utilization thresholds, enter util-threshold cpu 5sec all high 0 or no
util-threshold cpu 5sec {all | cp | lp slot-id | pe | rp }.
show util-threshold cpu
thresholds.
A threshold level of 0 disables Syslog and SNMP
– Display the configured values of CPU utilization
Control and Monitoring 195