Router Bgp - Dell C9000 Series Reference Manual

Usage Information You can use the redistribute command to advertise the IGP cost as the MED on
redistributed routes. When you set the route-map with metric-type internal and apply
outbound to an EBGP peer/peer-group, the advertised routes corresponding to those
peer/peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any other
parameters, the system redistributes all OSPF internal routes, external type 1 routes, and
external type 2 routes. RFC does not support this feature.

router bgp

To configure and enable BGP, enter ROUTER BGP mode.
C9000 Series
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Enter the AS number. The range is from 1 to 65535 (2 byte), from
1 to 4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted
format).
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol 500