Permit Udp - Dell C9000 Series Reference Manual

6 0001111000000000 1111111100000000 7680 7935 256
7 0001111100000000 1111111111000000 7936 7999 64
8 0001111101000000 1111111111111111 8000 8000 1
Total Ports: 4001
Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Rule# Data
1 0000000000000000 1111110000000000 0
Total Ports: 1024
Related
ip access-list extended
Commands
permit

permit udp

permit udp
To pass UDP packets meeting the filter criteria, configure a filter.
C9000 Series
Syntax
permit udp {source mask | any | host ip-address} [operator port
[port]] {destination mask | any | host ip-address} [dscp]
[operator port [port]] [count [bytes]] [order] [fragments] [log
[interval minutes] [threshold-in-msgs [count]][monitor]
To remove this filter, you have two choices:
Parameters
source
mask
any
host ip-address
— creates an extended ACL.
— assigns a permit filter for IP packets.
— assigns a permit filter for UDP packets.
• Use the no seq sequence-number command if you know the filter's sequence
number.
• Use the no permit udp {source mask | any | host ip-address}
{destination mask | any | host ip-address command.
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
non-contiguous.
Enter the keyword any to specify that all routes are subject to
the filter.
Enter the keyword host and then enter the IP address to specify
a host IP address.
Mask From To #Covered
1023 1024
Access Control Lists (ACL) 312