Version
6.1.1.0
Usage Information If you configure the set next-hop command, its configuration takes precedence
over the neighbor next-hop-self command in the ROUTER BGP mode.
If you configure the set next-hop command with the interface's IP address (either
Loopback or physical), the software declares the route unreachable.
Related
match ip next-hop
Commands
set origin
To manipulate the BGP ORIGIN attribute, configure a filter.
C9000 Series
Syntax
set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the no set origin command.
Parameters
egp
igp
incomplete
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
Description
Introduced on the E-Series.
— redistributes routes that match the next-hop IP address.
Enter the keyword egp to set routes originating from outside the
local AS.
Enter the keyword igp to set routes originating within the same
AS.
Enter the keyword incomplete to set routes with incomplete
routing information.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Access Control Lists (ACL)
385