Dell C9000 Series Reference Manual page 111

pattern pattern
sweep-min-size
sweep-max-size
sweep-interval
ointerface
Defaults none
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.3.7.0
8.5.1.0
8.4.1.0
(IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF. Default:
0xABCD.
Enter the minimum size of datagram in sweep range. The range
is from 52 to 15359 bytes.
Enter the maximum size of datagram in sweep range. The range
is from 53 to 15359 bytes.
Enter the incremental value for sweep size. The range is from 1
to 15308 seconds.
(IPv4 only) Enter the outgoing interface for multicast packets.
Enter the IP address in A.B.C.D format.
• For a Port Channel, enter the keyword port-channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
EXEC
EXEC Privilege
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Added support for the outgoing-interface option for link-
local IPv6 addressing on the S4820T.
Added support for the outgoing-interface option for link-
local IPv6 addressing on the S4810.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on the ExaScale.
IPv6 pinging available on management interface.
Control and Monitoring 111