Bgp Default Local-Preference - Dell C9000 Series Reference Manual

route-map map-
name
Defaults Disabled.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version
9.9(0.0)
9.2(1.0)
8.2.1.0
7.4.1.0
Usage Information If you enter bgp dampening, the default values for half-life, reuse, suppress,
and max-suppress-time are applied. The parameters are position-dependent;
therefore, if you configure one parameter, you must configure the parameters in the
order they appear in the command.
Related show ip bgp dampened-paths
Commands

bgp default local-preference

Change the default local preference value for routes exchanged between internal BGP peers.
C9000 Series
Syntax
bgp default local-preference value
To return to the default value, use the no bgp default local-preference
command.
Parameters
value
Defaults 100
Command Modes ROUTER BGP
Command History
Version
9.9(0.0)
(OPTIONAL) Enter the keywords route-map followed by the
name of a configured route map. Only match commands in the
configured route map are supported.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
– views the BGP paths.
Enter a number to assign to routes as the degree of preference
for those routes. When routes are compared, the higher the
degree of preference or local preference value, the more the
route is preferred. The range is 0 to 4294967295. The default is
100.
Description
Introduced on the C9010.
Border Gateway Protocol 570