Dell C9000 Series Reference Manual page 714

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Command Modes

EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, see the relevant

Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Usage Information To clear DCBX frame counters, use the clear dcbx counters interface stack-unit/port

To view the DCBX show output for multiple ports of a specified slot, you can specify any random

number of ports separated by commas or a hyphenated range of ports.

To specify a port range, you can enter a hyphenated range of one or more port range values

separated with commas; for example, show interfaces tengigabitethernet 10/0-1 dcbx

detail. To enter any random number of ports, you can enter a comma-separated string of port

numbers, for example show interfaces tengigabitethernet 10/2,4 dcbx detail

The following describes the show interface dcbx detail command shown in the following

DCBX Operational

Enter the port type.

Enter the slot/port number.

Introduced on the C9010.

Introduced on the S3048-ON and S4048-ON.

Introduced on the S6000-ON.

Introduced on the S6000.

Down status messages added.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the MXL 10/40GbE Switch IO Module.

The multiple port range value is supported only for the Gigabit Ethernet, 10-Gigabit

Ethernet, 40-Gigabit Ethernet, Fast Ethernet, FC, Port Channel, and VLAN interfaces.

Interface type with chassis slot and port number.

Configured the DCBX port role: auto-upstream, auto-downstream, config-

source, or manual.

Operational status (enabled or disabled) used to elect a configuration source

and internally propagate a DCB configuration. The DCBX operational status

is the combination of PFC and ETS operational status.

Data Center Bridging (DCB)

Chapters

Table of Contents